#Ethernet cinesync wont connect free

Ensure your subnet mask is not set to 0.Restore the Network settings to default in the Network menu in your DVR / NVR.In the DVR / NVR Network menu, ensure your system is set to DHCP instead of Static.The following instructions require you to access your system using your DVR / NVR and a monitor. If applicable to your system, look for a solid green light or flashing yellow light on the LAN port indicating connection.Connect your Ethernet cable into a different port on your router.If you cannot establish your connection, test your router by connecting it to another product with the same Ethernet cable.If you do not have a connection, connect your router to your DVR / NVR using a different Ethernet cable.To power cycle your DVR / NVR, please power it off and disconnect the power source for approximately 30 seconds. Connect your DVR / NVR to a router with an Ethernet cable.If you have completed the prerequisite steps and cannot connect to the Internet, check your Ethernet cable connections, router port connections, and DCHP settings. Set up your DDNS account with a Digimerge DVR / NVR.Set up your DDNS account with a FLIR Visible DVR / NVR.Set up your DDNS account with a Lorex by FLIR DVR / NVR.

#Ethernet cinesync wont connect free

Ensure that you have created a free DDNS account:.Ensure that you have completed Port Forwarding of your DVR / NVR system's ports to your router.If you have connected your DVR / NVR to your network router and it is not getting an Internet connection, or a valid IP address, check your Ethernet cable connection, router port settings, or DHCP / IP settings.